Setting Up The Calibration Parameters Manually - Loma IQ2 User Manual

Setting up the calibration parameters manually

Calibration parameters
The following table gives a summary of the calibration parameters you can edit in manual
setup mode.
Parameter
Working mode
Working
Min threshold
Max threshold
Threshold
Compensation
Head power
Head
The menus are only accessible if Manual Setup has been set to YES in the User option
menus.
These are explained in greater detail in the following sections:
To perform a manual setup
c
• Press , and then press
twice until the display shows Manual
setup.
e
to select Manual setup.
• Press
The options on the Manual Setup menu are normally set up by a Loma Service engineer and
should not normally be adjusted.
8024
Description
Dry, Reacts or Resists to specify the working mode.
Allows the working mode to be locked so it cannot be altered during
calibration.
The minimum acceptable threshold after calibration.
The maximum acceptable threshold after calibration.
Allows the threshold to be adjusted.
Allows the compensation value to be adjusted.
Can be adjusted between Max, 7 to 1, or Min to adjust the head power.
Allows the head power to be locked so it will not be adjusted
automatically during calibration.
V
Manual setup
63
Setting up the metal
detector