If The Transmission Fails; Using The Combination Dial Function - Minolta MINOLTAFAX 1600e Operator's Manual

3-11
How to Transmit a Document - Basics

If the Transmission Fails

If the transmission fails, a buzzer sounds
intermittently for 2 sec. and the Error
Indicator lights up.
The fax then automatically prints a TX RX
Result Report. For more details, see "TX RX
Result Report." pp. 9-3, 9-5
REDIAL ALL FAILED
TOKYO

Using the Combination Dial Function

When a dial registered as a Combination Dial is used, you can enter the Dial No. following the Combi-
nation Dial.
To register One Touch Dial No. or Speed Dial No. as a Combination Dial, enter "+" at the end of the
One Touch Dial No. or Speed Dial No.
In calling, enter the Combination Dial No. and Dial No. in this order.
How to use Combination Dial
Example: When the One Touch Dial 01 (OT1) has been registered as a Combination Dial,
1.OT1 + Dial No. (Numeric keys) + Start key
2.OT1 + One Touch Dial (which has not yet been registered as a Combination Dial)
3.OT1 + Speed Dial and Numeric keys + Start key
4.Redial (including Combination Dial)
5.OT1 + Start key
NOTE
• Entry should be made before specifying the receiver.
Entry is not accepted after a numeric key, One Touch Dial not registered as a Combination Dial, or
Speed Dial.
• Plural Combination Dials cannot be used together.
Calling only with the Combination Dial is possible.
• When a One Touch Dial or Speed Dial key is used after a Combination Dial, the slower communica-
tion speed is applied.
• Batch processing is possible when Group Dial, Program Dial, Timer Transmission or Communica-
tion Function is registered by using One Touch Dial or Speed Dial as a Combination Dial.
• Any registered Dial No., when it is changed or deleted, is deleted from the registration of Transmis-
sion (Calling) Stand-by Job and Program Key.
• An error occurs and transmission becomes impossible when combined numbers are registered to the
Combination Dial or when the total number of digits in a fax number exceeds 32.
For details about registering procedures, see "Registering One Touch Dial and Speed Dial".
Error
4503U3AI
Press the Stop key.
Stop
The Error Indicator will go out. Note the
reason for failure on the TX RX Result
Report and retry transmission or check to
insure the fax number is correct.
4503U309
4503U17I
p. 2-19