When An Unclear Print Is Produced - Minolta MINOLTAFAX 1600e Operator's Manual

12-9

When an Unclear Print is Produced

Take the following action if a faulty print is made. If good prints are not made even after these corrective
procedures, contact your Technical Representative.
Symptom
The image is light. "Print Density" in the SET utilities is not
properly set.
The Toner Cartridge is running out of toner.
The Drum Cartridge needs replacement.
The image is dark. "Print Density" in the SET utilities is not
properly set.
The Drum Cartridge needs replacement.
Partial void image. The paper loaded in the Paper Feeding Tray
is damp.
The Drum Cartridge needs replacement.
White line The Contact Image Sensor of the Scanner is
Black line dirty.
The Drum Cartridge needs replacement.
Uneven image Toner is uneven inside the Toner Cartridge.
density.
The Drum Cartridge needs replacement.
Cause Action
Set "Print Density" to an appropriate level.
pp. 8-2, 8-4
Remove the Toner Cartridge and shake it sev-
eral times.
Replace the Toner Cartridge with a new one.
p. 11-3
Replace the Drum Cartridge with a new one.
p. 11-5
Set "Print Density" to an appropriate level.
pp. 8-2, 8-4
Replace the Drum Cartridge with a new one.
p. 11-5
Replace the paper in the Tray with a new, dry
supply. pp. 11-1
Replace the Drum Cartridge with a new one.
p. 11-5
Clean the surface of the Contact Image Sen-
sor. p. 11-8
Replace the Drum Cartridge with a new one.
p. 11-5
Remove the Toner Cartridge and shake it sev-
eral times. p. 11-3
Replace the Drum Cartridge with a new one.
p. 11-5