Minolta MINOLTAFAX 1600e Operator's Manual page 221

12-3
When a Message Appears
Message
*CAUTION* While your fax was scanning a document
MEMORY FULL for memory TX, the memory became full
and the fax was unable to send the entire
document through memory TX.
*CAUTION* While the fax was receiving a document
MEM. FULL/RX during mailbox RX, memory RX, or mem-
CANCEL ory substitute RX the memory became full
and you are unable to execute RX using the
memory.
*CAUTION* While the fax was scanning the document
MEMORY FULL for Convenient Copy, it ran out of memory
volume and was unable to perform the func-
tion.
*CAUTION* The Document Feeding Tray has run out of
NO PAPER paper.
*CAUTION* The size of the paper registered using the
PAPER SIZE SET utilities does not represent that actually
ERROR loaded in the Document Feeding Tray.
*CAUTION* The fax has run out of Toner.
TONER EMPTY
*CAUTION* The Scanner Cover is open or loose.
SCANNER
COVER OPEN
*CAUTION* The Printer Cover is open or loose.
PRINTER COVER
OPEN
*CAUTION* A document misfeed has occurred.
ORIGINAL DOC.
JAM
*CAUTION* A paper misfeed has occurred.
RECORDING
PAPER JAM
*CAUTION* Machine Trouble.
MACHINE A fault has occurred in the machine.
TROUBLE
Cause/Symptom Action
• To transmit the portion of the document that
has been scanned into memory:
• Press the Start key.
In order to increase memory capacity, print any
documents which may be stored in memory or
wait until some memory transmissions have
been completed; then retry memory TX.
• To cancel what has been scanned into memory:
p. 6-1
Press the Yes key.
In order to increase memory capacity, print any
documents which may be stored in memory or
wait until some memory transmissions have
been completed; then retry memory TX.
Press the Stop key and print any documents
stored in memory onto paper to increase the
memory capacity. Then, ask the other party to
retry transmission. pp. 4-17, 5-19, 5-22
Press the Stop key and print any documents
stored in memory onto paper to increase the
memory capacity. Then, try Convenient Copy
again. p. 7-3
Add paper. p. 11-1
Change to the paper that has been programmed
or change the setting of the paper size of the SET
utilities to represent the paper size actually
loaded in the tray.
pp. 11-1, 11-2
Change the Toner Cartridge.
Close the Scanner Cover.
Lock the Printer Cover in position.
Clear the misfeed by following the procedure
given in "Clearing a Document Misfeed."
p. 12-4
Clear the misfeed by following the procedure
given in "Clearing a Paper Misfeed."
p. 12-5
Call your Technical Representative.
p. 6-1
p. 11-3