Retrying The Same Destination (Redial Tx); Using Manual Redial - Minolta MINOLTAFAX 1600e Operator's Manual

6-3

Retrying the Same Destination (Redial TX)

Redial TX redials the destination the fax has previously dialed, but not connected to. The following
two sub-features are available.
Auto Redial
If the line is busy, the fax temporarily stops dialing and, several seconds later*, it dials the other party
again. This redialing sequence is repeated several times*.
Manual Redial
The party the fax dialed last is redialed by the touch of a key.
NOTE
• Auto Redial has been factory-set and so there is no need to set it.
• The redial interval time and number of redials vary depending on the country in which the fax is
used. Consult your Tech. Rep. for more details.

Using Manual Redial

1
Check that the message "SET DOC. FACE
DOWN" is shown on the Message Display.
JUN. 8 15:38
- SET DOC. FACE DOWN -
Make the necessary settings and load the
document (so that the fax is ready to transmit
it). pp. 3-1, 4-1, 5-1, 6-1
2
Press the Redial key.
Redial/Pause
The fax starts redialing the party which it
dialed last. When the line is connected, the
document is fed in and transmission is
started.
3
To stop the transmission, press the Stop key.
100%
4503U229
NOTE
Redialing is not possible if the last transmis-
sion was a Broadcast or Group Transmission
to multiple destinations.
4503U14I
Stop
4503U17I