Letting The Other Party Execute The Transmission Of Your Document (Polling Tx) - Minolta MINOLTAFAX 1600e Operator's Manual

4-21
Letting the Other Party Execute the Transmission of Your
Document (Polling TX)
Polling TX lets the other party give a command to transmit a document to that party which has been
put in the standby state.
Polling TX can be either one of the following two modes.
• Single mode:
When in this mode, you place your document on the Document Feeding Tray and wait for a trans-
mission command from the other party. When the document is transmitted upon receipt of a trans-
mission command from the other party, the document is fed out. This mode is used when there is
only one party involved that polls you for transmission of a document. It is also used when the mem-
ory still available for use is small.
• Multi mode:
When in this mode, the fax scans the document to be transmitted into memory and goes into standby
mode waiting for a transmission command from the other party. Even after the document has been
transmitted, the memory retains the contents of the document so that the fax can transmit the same
document on receipt of another transmission command from another party. This mode is used when
there will be more than one party which will poll for transmission of a document.
1
• Check that the message "SET DOC. FACE
DOWN" is shown on the Message Display.
• Make the necessary control panel settings
and load the document (so that the
document can be immediately transmitted).
• Press the Function key.
Function
FUNCTION
SEL. 0 - 7 / OR FUNCTION
2
p. 4-2
4503U09I
4258U106
Press "6" of the Numeric keys to select
Polling TX.
MNO
6
6 POLLING TX
4503U450
4503UF6I
4503U426