If The Transmission Fails; Using The Speed Dial Function - Minolta MINOLTAFAX 1600e Operator's Manual

3-9
How to Transmit a Document - Basics

If the Transmission Fails

If the transmission fails, a buzzer sounds
intermittently for 2 sec. and the Error
Indicator lights up.
The fax then automatically prints a TX RX
Result Report. For more details, see "TX RX
Result Report." pp. 9-3, 9-5
REDIAL ALL FAILED
TOKYO

Using the Speed Dial Function

The Speed Dial function allows you to transmit a document to a particular party by just entering a 2-
digit number assigned to that party. To use this function, however, you must first program the fax num-
ber and other data for each party into the Speed Dial key.
You can also register the PC access number when the destination fax is connected to a PC.
Data for up to 100 different parties can be registered for Speed Dial.
Error Manual RX
PC
Standard
Fine (S-Fine)
Half Tone
Resolution
Memory TX
For more detailed registering procedures, see "Registering One Touch Dial and Speed Dial Stations."
p. 2-19
1
Check that the message "SET DOC. FACE
DOWN" is shown.
JUN. 8 15:38
- SET DOC. FACE DOWN -
Select the resolution according to the
characteristics of the document.
Error
4503U3AI
4503U309
Set
Confirm Function
100%
4503U229
p. 2-19
Press the Stop key.
The Error Indicator will go out. Note the
reason for failure on the TX RX Result
Report and retry transmission or check to
insure the fax number is correct.
No
Yes
2
Place the document on the Document
Feeding Tray.
p. 3-4
Stop
4503U17I
Speed Dial
Redial/Pause
4503U323
4503U321