Minolta MINOLTAFAX 1600e Operator's Manual page 164

6
The pages of the document which the fax has
scanned are fed out.
The fax starts transmitting the document
after it has completed storing all the data in
memory.
NOTE
The fax may not be able to store the data if the
memory available for use is not enough to
accommodate the data.
Example:
JUN. 8
- SET DOC. FACE DOWN -
If this happens, wait until there is enough mem-
ory available or cancel Memory TX and trans-
mit the document without using memory.
Or other jobs previously stored in memory can
be printed out to provide memory space for
your new document.
When a document for transmission has been
stored in memory
Output a Memory Image Print.
Check the contents of the document, remove it
from the memory, and after the current docu-
ment has been transmitted, make the job setup
again for that document.
When a document received has been stored in
memory
Print the document received according to the
required procedure.
• Memory RX p. 5-19
• Mailbox RX p. 4-17
15:38 7%
4503U611
pp. 9-1, 9-8
Transmitting a Document Using Memory (Memory TX)
NOTE
The following message appears if the memory
becomes full while the fax is scanning a docu-
ment.
MEM. FULL / TX CANCEL
OK = YES
• If you would like to transmit the portion of the
document stored in memory, press the Start
key to select TX. The fax transmits the portion
of the document which was stored in memory.
• If you want to delete the portion of the docu-
ment which was stored in memory, press the
Yes key to select Cancel. This deletes the con-
tents of the document. Follow the instruction
in the NOTE in step 6 to call up a document
stored in memory and increase the memory
volume before attempting to make a memory
TX.
• If you fail to make a choice within 1 min. after
the above message has appeared, the contents
of the document will be automatically
deleted.
6-2
(TX=START)
4258U229