Minolta MINOLTAFAX 1600e Operator's Manual page 26

xviii
10. Please be advised that should another telephone device be used connected to the PSTN via the serial
socket on the LJU unit, then problems may be experienced in the following ways.
(1) Difficulty making calls.
(2) Problems in telephone conversation sometimes experienced by both parties. Should difficulties as
described above be experienced, then the supplier of the facsimile should be contacted for assistance
and not the network operator.
11. The facsimile is not suitable as an extension to a pay phone or as a 1 + 1 carrier system.
12. To this machine on a private exchange (PABX) extension, insert a pause or pauses in the autodial
sequence to allow your PABX unit time to connect with the public service telephone network (an out-
side line) before dialing continues. For example you may require a sequence of 9 "PAUSE" 0908
214315 to transmit a fax message to our Keynes Office.
To insert pause, press the "PAUSE" key. One key operation causes a pause of 3.5 seconds in the dial-
ing sequence.
13. Use of the facsimile to make overseas fax transmissions, it may be necessary to insert a pause in the
autodial sequence when sending transmissions overseas in order that the international exchanges have
time to interconnect. For example you may require a sequence of 010 "PAUSE" 1555677899 to trans-
mit a fax message to your New York office.
To insert a pause, press the "PAUSE" key. One key operation causes a pause of 3.5 seconds in the dial-
ing sequence.
This equipment is fitted with a moulded type mains plug incorporating a detachable fuse cover; under
no circumstances should the plug be used without the fuse cover fitted. In the unlikely event of the
socket outlet in your home not being compatible with the plug supplied, cut off the main plug and fit
an appropriate type observing the wiring code blow.
The fuse from the cut-off plug should be removed and the plug should be disposed of
DANGER:
in a safe manner. Under no circumstances should the cut-off plug be inserted into a
socket outlet as a serious electric shock may occur.
If you are not sure how to do this, get help from a qualified electrician.
The wires in this mains lead are coloured in accordance with the following code:
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows. The wire which is coloured
GREEN-AND-YELLOW must be connected to the terminal in the plug which is marked by the letter
E, or by the safety earth symbol, or coloured green or green and yellow.
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter
N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked with the let-
ter L or coloured red.
This apparatus must be protected by a 13A fuse in the mains plug or distribution board.
"WARNING: THIS EQUIPMENT MUST BE EARTHED."
MAINS PLUG WIRING INSTRUCTIONS
IMPORTANT
GREEN-AND-YELLOW: Earth
BLUE: Neutral
BROWN: Live