Printronix L5000 Series Maintenance Manual page 95

3. Remove the screws (4) securing the LED print head, then lift the print head to
remove it.
Do not touch the surface of the print head, as you will leave fingerprints.
4. When installing the LED print head, insert the alignment pins (2 pins – 1 right, 1
left) into the center holes as shown. Place the LED print head in its original
position. Make sure the alignment pins align with the holes on the print head.
Mechanical System
CAUTION
Screws
LED print head
Alignment pin
LED print head
10–71