Printronix L5000 Series Maintenance Manual page 111

4. Disconnect connector J11 and TRG from the flash power supply.
5. Open the cover of the AC line casing, and disconnect AC lines "L" (black) and
"N" (white).
6. Remove the screw fastening the FG wire to the base frame.
Connector J11
(to MPU)
Handle
AC line
7. Lift the high–voltage terminal cover and remove the high–voltage cables by
removing the hex nuts in the terminal cover.
High–voltage cables
Screws
Mechanical System
FG
Hexagonal nuts
High voltage
terminal cover
(to lamps)
Connector TRG
(trigger, to lamp
thermistors)
10–87