Printronix L5000 Series Maintenance Manual page 291

4. To remove the stacker, press the release lever (located on the front side) to
remove the hooks from the studs.
The power paper stacker contains the following keys for operating the elevator:
AUTO: Sets the elevator in automatic mode. Pressing this key causes the
elevator table to rise until it reaches its maximum upper position and enables the
stacker.
STOP: Stops the elevator, and displays the message "Stacker Not Ready" on the
printer control panel. The STOP key may be used to stop the elevator from
lowering after pressing the DOWN key.
DOWN: Lowers the elevator until it reaches its maximum lower position, or
until the STOP key is pressed.
PAPER MODE (switch located on the back of the stacker): ON equals "Heavy
Mode" (LED is lit); OFF equals "Normal Mode" (LED is not lit). This switch is
only active in STOP mode and when there is no paper in the stacker.
When operating the power stacker in Heavy Mode, the maximum stack height
following a cut or page eject depends on the page length, as shown in the table
on the following page.
Optional Power Paper Stacker
Release
lever
E–9