Table of Contents
Advertisement
8. Remove the screws (2) fastening the flash power supply.
9. Grasp the flash power supply and pull it out. If you cannot pull it, loosen the
screws (4) fastening the metal fittings on the rear of the flash power supply and
try again.
Screws
10. Insert a new flash power supply.
11. Align the screw hole on the flash power supply with the one on the printer base,
then insert the screws and tighten them firmly.
12. Firmly tighten the screws (4) on the metal fittings loosened above.
13. Attach the connectors and cables to their original positions.
10–88
Front side
Screw
Rear side
Metal fittings
Screw
Mechanical System
Advertisement
Chapters
Table of Contents
