Printronix L5000 Series Maintenance Manual page 117

1. Remove the E–ring securing the tractor splined shaft and remove the screw (1)
securing the tractor shaft on the front side.
2. Remove the tractor drive belt (see page 10–52).
3. Slide the tractor splined shaft to the rear side.
4. Remove the screw securing the tractor shaft on the rear (shown above), and
remove the tractor from the paper feed side.
NOTE: After removing and replacing tractors, perform the procedure on the
Mechanical System
following page to adjust the tractors.
Screw
E–ring
Tractor spline shaft
Screw
10–93