Printronix L5000 Series Maintenance Manual page 50

4. Loosen the screw fastening the pre–charger to the printer unit, and then remove
the separator claw block from the front.
5. When removing the separator claw solenoid, the screws (2) securing the
solenoid, and the E–ring on the tip of the solenoid arm must be removed.
a. Remove the springs adjacent to the separator claw.
b. Remove the E–ring on the tip of the shaft and loosen the setting screw
Bushing
NOTE: When assembling the separator claw shaft to the main unit, adjust the
10–26
securing the roller.
Screws
Stopper
S Spring
Separator
claw unit
position of the roller so that there is no wobble.
S Spring
E–ring
Replacement Procedures