Table of Contents
Advertisement
Transport belt
When replacing the transport belt, the transfer/transport unit must be turned
upside–down. When turning the unit upside–down, be sure to put a rest underneath it
to protect the protruding tips of the sensor levers. Also, be careful when handling the
lever.
1. Remove the vacuum fan and disconnect the two (2) sensor connectors.
2. Disconnect the cables from the three (3) cable clamps.
3. Restore the transport unit to its original position. Remove the screws (2 on the
front, 2 on the rear) securing the output guide, and then remove the output guide.
Output
Guide
10–34
Connector
Screw
Vacuum fan
Mechanical System
Advertisement
Chapters
Table of Contents
