Printronix L5000 Series Maintenance Manual page 330

6. Remove the eight stacker belts by slightly moving the two D–shaft assemblies to
the rear side.
Before moving the D–shaft assembly, be sure to slacken the belt at the rear side.
See step 5 on page E–34.
7. Replace the stacker belt.
When installing the stacker belts on the beater belt unit frame, set the belts
while shifting them by one pitch, as shown below. Also refer to the illustration
on the following page.
Beater belt
unit frame
E–48
IMPORTANT
BELT D (S3M–300–6)
IMPORTANT
Optional Power Paper Stacker