Table of Contents
Advertisement
2. Remove the screws (3) fastening the motor cover, then remove the motor cover
by moving it downward.
3. Remove the E–ring and the tab washer from the motor shaft.
4. Loosen the set screw using the hex wrench, and remove the flywheel.
5. Remove the screws (4) which hold the drum motor to the pointer base, then
remove the drum motor from the paper feed area.
6. Disconnect the connectors (2) and remove the drum motor. Now, you can install
a new drum motor.
10–48
Motor cover
Screw
Set screw
Flywheel
Tab washer
E–ring
Mechanical System
Advertisement
Chapters
Table of Contents
