Printronix L5000 Series Maintenance Manual page 60

6. Remove the base conveyer from the unit frame. Remove the screw (1) fastening
the high–voltage wire, and remove the wire.
7. Remove the E–rings (2) holding the drive shaft to the base conveyer, then slide
the bearing off the shaft to remove it.
8. Remove the drive shaft from the base conveyer, and remove the three (3)
transport belts.
9. When replacing the transport belt, be careful to distinguish the new belt's front
surface from the back surface. The front looks like graph paper, while the back
has an irregular pattern. Adjust the distance between the drive shafts according to
the length of the belt.
10–36
E–ring
Transport belt (3)
Bearing
Drive shaft
Mechanical System