Printronix L5000 Series Maintenance Manual page 103

Drum cleaner set sensor
The drum cleaner set sensor is a limit switch to detect whether the drum cleaner is
set. It is assembled to the inside of the rear panel so that the points close when the
drum cleaner is set.
Drum Cleaner Set Sensor
To remove this sensor, disconnect the connector on the rear side, remove the screws
(2) securing the bracket, put your hand in from the top of the rear panel and extract
the sensor with the bracket attached, and remove the screws (2) securing the sensor to
the bracket.
Bracket
Screw
Screw
Mechanical System 10–79