Table of Contents
Advertisement
Floppy Disk Drives
1. Remove the printer rear cover (page 10–102).
2. Remove the controller module side panel (page 10–106).
3. Disconnect the interface cable and power cables from the floppy disk drives.
4. Remove the screws (4) which hold the two disk drive brackets to the controller
module. Remove the bracket and floppy disk drives from the printer (page
10–110).
5. Remove the screws (2) which secure each drive to the bracket.
6. To install the disk drives, reverse the above steps.
Mechanical System
10–109
Advertisement
Chapters
Table of Contents
