Table of Contents
Advertisement
Floppy Disk Drives (not used on printers with flash memory)
1. Turn off the printer.
2. Unplug the printer AC power plug from its electrical outlet.
3. Open the lower front cover (page 4–6).
4. Remove the controller module side cover (page 4–105).
5. Disconnect the interface cable and power cables from the floppy disk drives. If
necessary, tag the interface cables for identification, to ensure that each cable is
reconnected to its proper drive later.
6. Remove the screws (4) which hold the two disk drive brackets to the controller
module. Remove the bracket and floppy disk drives from the printer (page 4–105).
7. Remove the screws (2) which secure each drive to the bracket.
8. To install the disk drives, reverse the above steps.
When installing floppy disk drives, be sure that you connect each interface
cable to the correct floppy disk drive.
4–104
IMPORTANT
Replacement Procedures
Advertisement
Table of Contents
