Installing And Connecting Sources - Christie CP2000-X User Manual

2.5 Installing and
Connecting
Sources
CP2000-X User Manual
020-100031-01 Rev . 1 (03-2009)
Never disable a vane switch. Attempting to operate the
projector without monitoring airflow can result in
dangerous overheating of the projector.
Side-Venting Duct (Adapter)
All stacks require a special side-venting duct adapter between projectors, otherwise
the top projector blocks exhaust from the top of the bottom projector. This Side-
Venting Exhaust Adapter Kit is required on any bottom projector used in an upright
stack of two.
Liquid Cooling
During operation, a closed loop of flexible tubing circulates liquid coolant from a
small reservoir to critical electronic components located near the front of the
projection head. The coolant (a 50/50 mix of distilled water and ethylene glycol)
should fill slightly more than half of the reservoir to ensure adequate circulation. The
reservoir, which is located in the igniter compartment, is factory-filled and does not
require draining before projector transit. Top up as necessary.
Check regularly for leaks and proper liquid level.
Connect your
CINEMA:
server/source to either the
or
HD-SDI A HD-SDI B
connector on the
Communications and
Source Connection Panel
at the rear of the
projector. Connect two
independent sources, or
connect a single source to
both ports to create a
dual-link cinema input.
To display
NON-CINEMA:
alternative content from a DVI source or from Christie's Cine-IPM 2K, remove the
access panel located on the underside of the projector near the air filter. Connect two
independent sources, or connect the Cine-IPM 2K to both ports for 10-bit processing.
Add an exit hole to the panel, or leave the panel off.
INSTALLATION AND SETUP
WARNING
WARNING
Figure 2.27. Connecting Cinema and Non-Cinema
2-23