Christie CP2000-X User Manual page 10

INSTALLATION & SETUP
2-2
Connect a Source
Connect your desired source
to the appropriate HD-SDI
(cinema) connector(s) on the
Communications and Source
Connection Panel at the rear
of the projector.
NOTE: To connect other types of
sources, such as alternative
content through DVI or
Christie's Cine-IPM 2K, you
must remove the access panel
located on the underside of the projector near the air filter. Drill an exit hole or
leave the panel off.
Connect to Lamp Ballast and Power

STEP 5
Figure 2.2. Access to Cinema and Non-
Cinema Ports
WARNINGS
• Connect all 4 cables to the projection head prior to
turning the ballast breaker on.
• Follow all labeling exactly.
Figure 2.3. Connect Head to Ballast
CP2000-X User Manual
020-100031-01 Rev. 1 (03-2009)