Christie CP2000-X User Manual page 150

ASCII MESSAGES
B-4
Function Code / Examples
(PRM?)
(PRM!001)
Projector Address (ADR)
(ADR "192.168.206.10")
(ADR?)
(ADR!"192.168.206.10")
Projector Configuration File (PCF)
(PCF "TPC1")
(PCF?)
(PCF! "TPC1")
Projector Hours of Use (PJH)
(PJH?)
(PJH!5672)
Projector Running Hours (PRH)
(PRH?)
(PRH!1251)
Save (SAV)
(SAV)
Screen Format (SCF)
(SCF "filename")
(SCF?)
(SCF!"1920x1080")
Screen Orientation (SOR)
(SOR 0)
(SOR?)
(SOR!0)
Select Input (SIN)
(SIN 0 )
Select Source Format (SRF)
(SRF "filename")
(SRF?)
(SRF!"1280x1024square")
Shutter (SHU)
(SHU 0)
(SHU 1)
System Status (SST)
Description and Parameters
full cinema processing path and 1= non-cinema only.
What is the current processing path?
Non-cinema processing path is currently in effect
Sets which projector—identified by its network address—
will be controlled by the TPC upon the next re-boot.
Examples might include 192.168.206.10 or 192.168.206.11,
etc. Valid IP addresses depend on the site.
Which projector (I.P. address) is controlled by the TPC?
Projector 192.168.206.10 is controlled by the TPC.
Use this pre-defined projector configuration file (PCF
"filename") for processing.
What pre-defined processing file is currently in effect?
The TPC1 pre-defined proj. configuration file is in use
How many hours have been logged on the projector?
#hours that the projector has been used (incl. standby
and without a lamp)
Maximum=16,777,215 hours
How long has the proj. been run with the lamp on?
Proj. has run 1251 hours with the lamp on
Immediately save all changes to flash rather than waiting
for eventual auto save or a power down.
Use this screen format file (stored in projector memory).
What is the current screen format?
Current screen format filename is 1920x1080
Sets the position of the projector relative to the screen
0=Normal Front
1=Inverted Rear
2=Normal Rear
3=Inverted Front
What is the current screen orientation setting?
Current screen orientation is normal front position
Select which projector (P1) and input (P2) to use.
P1 = Projector (always 0)
P2 = Input
0=Input A (SMPTE/cinema)
1=Input B (SMPTE/cinema)
2=Dual SMPTE/cinema
3=DVI-1 (non-cinema)
4=DVI-2 (non-cinema)
Select the stored source file defining incoming resolution
and desired aspect ratio for the current display.
What is the current source format?
Current source format filename is 1280x1024square.
Open or close the electronic "quick douser", where 0 =
open and 1 = closed
Method of reading projector information. See Messages
With Multiple Parameters later in this Appendix.
CP2000-X User Manual
020-100031-01 Rev. 1 (03-2009)