Christie CP2000-X User Manual page 12

INSTALLATION & SETUP
2-4
HEAD-TO-AC:
Christie-supplied IEC 320
(220V) 15-amp line cord to a
single phase 208V AC
supply. Do not substitute
other cords. Input power
required is 200 - 240 VAC
(±10%), 50 to 60 Hz @ 3
amps for 208 V.
WARNING
Do not attempt operation if
the AC level is not within
the specified voltage and
power range for the
projection head
(180-265 AC).
EXTRACTOR:
Lamp, & Cooling
At this point, the projection head is ready for use:

The voltmeter should display the incoming voltage

PROJ. STATUS

Light engine compartment fans near the front should be running

Remainder of projection head will be off
Set Lamp Type and Cable Length

STEP 6
NOTE: Service/installer required.
Connect the
Figure 2.5. Connecting Projection Head
Also plug the extractor fan into the projector. See 2.4, Installing a Lens,
light should be green
WARNING
Explosion hazard. Keep the projection head OFF until
you have defined which lamp type is installed.
to AC Supply
CP2000-X User Manual
020-100031-01 Rev. 1 (03-2009)