Christie CP2000-X User Manual page 154

ASCII MESSAGES
For Your Information (FYI) 
History (HIS) 
System Status (SST) 
B-8
FYI messages are generated and broadcast when an overall change in the projector's
status is detected. Each FYI message identifies the IP address of the TPC generating
the message, followed by a code for the change as well as one or more parameters of
descriptive details about what has changed.
NOTES: 1) Because FYI messages are gated by the Error Message Enable (EME)
control, disabling serial error message also disables FYI messages. 2) FYI messages
do not occur unless there is a Cine-IPM present (Cine-IPM is not available for CP
projectors).
A number of lamp histories are stored in memory, with the oldest discarded when
there is no more room. An accurate lamp history requires that the serial# for a new
lamp be recorded when the lamp is installed. HIS message parameters are:

P1 = Lamp order (oldest lamp installed = 001, next oldest = 002, etc.)

P2 = # of hours logged

P3 = Lamp serial#

P4 = #strikes

P5 = Installation date & time
The SST message provides a variety of information about the current state of the
projector. The single broad-ranging request
return of a series of replies as if multiple requests had been sent. In each of these
replies, P1 explains the general content or topic of that reply, and P2 the individual
details. To obtain status for one topic only, specify the desired P1parameter
corresponding to that topic—for example, the request
projector information only. For a specific single-status inquiry, include both P1 and
P2 in the request—for example,
installed.
for all information triggers the
(SST?)
(SST?0)
asks what version of SSM main software is
(SST?4 3)
will trigger general
CP2000-X User Manual
020-100031-01 Rev. 1 (03-2009)