List Of Components - Christie CP2000-X User Manual

1.2 List of
Components
Variations in CP2000-X Use
CP2000-X User Manual
020-100031-01 Rev . 1 (03-2009)
The following components make up a complete CP2000-X system (see Figure
3.1):
 Projection Head. Includes:

Line cord

Touch Panel Controller with mounting hardware and 3-ft. cable

Standard and high-security keys for lamp and igniter service access, plus
assorted Allen keys

CP2000-X User's Manual
 Lamp Ballast (three-phase 7 kW for all lamps in all countries)
 Choice of lamp kit (incl. protective gear)
 Cable kit (incl. two lamp power cables and two communication/control
cables)
 Extractor Kit, 50/60 Hz
 Choice of high-contrast or high brightness lenses (does not include auxiliary
lens or mount—both optional)
 Optional FredFrame (includes fork lift rails for bottom).
 Optional Rack Stand

The universal ballast in the CP2000-X offers adjustable lamp
POWER LEVELS:
power to suit the size of lamp currently in use. Software allows each lamp to be
"over-driven" by approximately 10% of its maximum rating.
The four CP2000-X lamps are listed below:
LAMPS:
* For this projector, the 2.0 kW is available in CDXL only (maximum performance)
** Available as CDXL (maximum performance) or CXL (less expensive).
Optional Christie components include an auxiliary lens mount and lens,
OTHER:
DCP Librarian setup software, and a 50-ft TPC cable. Refer to the complete
option list in Section 8.
CP2000-X Lamps CP2000-X Ballast
2.0 kW *
3.0 kW **
4.5 kW **
6.0 kW **
Refer to full specifications in Section 8.
INTRODUCTION
7 kW
7 kW
7 kW
7 kW
1-3