Christie CP2000-X User Manual page 23

Hoisting and Stacking
CP2000-X User Manual
020-100031-01 Rev . 1 (03-2009)
Special Orientations
Since this projector cannot be inverted or tilted beyond 15 during use, all
installations are front-mount and require the "Normal Front" Image Orientation
setting in the Admin: General menu. For shipping, remove lamp and rotate the
projector box as needed.

For some installations such as large venue rental/staging applications, you will likely
have to safely lift or hoist this projector—or a stack of 2 projectors—into place. Keep
in mind the following critical safety guidelines for all handling of the projector.
Carrying/Moving the Projection Head
Four or more people can lift and hand-carry one projection head (with or without a

FredFrame ) a short distance as required. Never attempt to carry a stack by hand. To
use equipment such as a forklift to move the projection head, always install a

FredFrame first.
Using a Forklift
Do not attempt to use a forklift without first installing the
fork lift rails on the bottom of the FredFrame
otherwise the base of the projector may crush and
Strong extruded rails that mount to the bottom of the FredFrame
forks from a forklift, and are mandatory for this method of transport. Do not lift the
projection head with equipment unless the FredFrame
installed. Always follow the instructions provided with the FredFrame
Using the FredFrame
To hoist, stack and/or "fly" projectors, you must properly secure each projection head
within a FredFrame 
suspend this assembly. If desired, the lamp ballast can also be hoisted and flown from
its integral rigging bars. Follow the instructions provided with the FredFrame
Figure 2.19. Side-to-Side Tilt
WARNING
damage internal components.

and use appropriate rigging and safety cables to raise and/or
INSTALLATION AND SETUP

,

accommodate

and forklift rails are

kit.
 kit.
2-15