Power-Down Procedure; Introduction To The Touch Panel Controller - Christie CP2000-X User Manual

3.3 Power-down
Procedure
3.4 Introduction to
the Touch Panel
Controller
C ontroller
CP2000-X User Manual
020-100031-01 Rev . 1 (03-2009)
NOTE: Manual shut-down only. Your system may include automation.
1. Press the lamp button on the Main menu to turn the lamp off. You must hold the
button down briefly.
2. Wait at least 10 minutes so that fans continue to cool the lamp.
3. Set the ballast breaker to
Most users will use the Touch Panel Controller (TPC) as their main interface with
the projector. Depending on the installation, this Windows-based touch-sensitive
screen is typically mounted on the rear of the projector or at some other convenient
nearby location. Installers must pre-program it appropriately for use at the specific
site.
User Access and Rights
Whether or not you can access specific TPC menus and functions depends on how
you have logged on to the TPC. See Figure 3.2.
For the general user having no username or password, the Touch
GENERAL USERS:
Panel Controller (TPC) offers three menus providing:
 On/Off toggling of the lamp, shutter, user test patterns, and pre-configured
displays.
 Basic status and/or diagnostic information about projector components.
 Versions of software components currently installed.
Figure 3.2. Map of TPC User Access Rights
WARNINGS
Wait for the cooling fans.
.
OFF
BASIC OPERATION
3-7