Christie CP2000-X User Manual page 64

BASIC OPERATION
3-22
L/R INPUT REFERENCE NOTES:
Select the option matching your source type and how the 3D sync is supplied:

A= LEFT, B= RIGHT:
via 2 cables at the
A
is included with the image data inputs rather than supplied separately at the GPIO
port.

WHITE LINE or BLUE LINE
an embedded white or blue line at the bottom of each frame identifies left vs.
right, and an additional separate 3D stereo sync input at the GPIO port is not
present. Short line=Left, long line=Right.
NOTE: Requires single 3D input. Not currently supported.
 : Select only if using a single 3D signal requiring a separate 3D
ASSIGNED GPI
stereo sync input at the GPIO.
NOTE: Requires single 3D input; not currently supported.
L/R DISPLAY REFERENCE NOTES:
Select the option describing how you are supplying the 3D stereo sync signal to the
projector:
 Select Not Used if your 3D source provides separate left and right
NOT USED:
data via 2 cables at the
data includes the 3D stereo sync signal—an additional separate 3D stereo sync
input at the GPIO port is not used.

: Select only if using a single 3D input signal requiring a separate
ASSIGNED GPI
3D stereo sync input at the GPIO.
NOTE: Requires single input; not currently supported.
L/R OUTUT POLARITY NOTES:
 : 3D L/R sync output (from GPO) will match L/R of sync input.
TRUE
 : 3D L/R sync output (from GPO) will be the opposite of sync input
INVERTED
(left becomes right, and right become left).
FRAME RATE N:M NOTES:
Increase the display frame rate as necessary to reduce flicker from your source(s).
These "N:M" ratios define how many frames to display per number of frames that
Select if your 3D source provides separate left and right data
and SMPTE ports. This assumes the 3D stereo sync signal
B
: Select only if using a single 3D input signal in which
and SMPTE ports. In this configuration, the image
A B
form 1 complete image. For all 3D use, the bottom value
is 2, indicating that two frames—left and right—are
combined into every complete display frame. Set to the
highest rate possible without image cropping.
CP2000-X User Manual
020-100031-01 Rev. 1 (03-2009)