Christie CP2000-X User Manual page 84

BASIC OPERATION
C ontroller
Figure 3.27. Source Selection on Main Menu
(SAMPLE)
NOTES: 1) Depending on your expected needs, your installer may or may not have
configured all eight buttons for use. 2) Buttons may have any icon and/or text.
For any channel button on the
WHAT HAPPENS WHEN A BUTTON IS SELECTED?
Main menu, the projector interprets incoming signal data according to one of eight
user-selectable display setups defined at the time of CP2000 installation (and/or with
each subsequent release of a new digital cinema feature) and stored in projector
memory. Each display setup consists of Projector Configuration File (PCF)
information as well as additional processing, display parameters and screen settings
optimized for a particular cinema feature or alternative content source. For proper
processing and display of a source, press pre-assigned channel button (see Figure
3.27) corresponding to the setup you wish to use—the button will then appear
recessed and the projected image will update according to the display setup assigned
to this button. No further adjustment of the image should be necessary. To change to
a different presentation, select a different channel button.
Display setups for digital cinema servers are
CINEMA VS. NON-CINEMA SOURCES —
carefully configured when the projector is installed so that presentations will be
automatically optimized and require no further adjustment. A user need only select
the relevant channel button. Displays of non-cinema or other "alternative content",
such graphics or video sources connected to DVI ports, are also usually pre-
configured for easy selection. Consult Section 5 for details about non-cinema
applications and display adjustments.
Other Methods of Source Selection
Depending on your installation, you may be able to select a source via
communication from a different controller.
Regardless of how the display file is selected, the feature will appear on screen
according to the specific display settings recorded in that file. If the screen display
does not appear as expected, this indicates that the display setup is incorrectly
configured for the incoming source. Try a different display file. If the image is still
incorrect, the display setup may first have to be re-configured with new settings.
Contact the trained operator responsible for updating display setups.
3-42 CP2000-X User Manual
020-100031-01 Rev. 1 (03-2009)