Christie CP2000-X User Manual page 26

INSTALLATION & SETUP
Install First Lamp
2-18

Remove the lamp door and open the empty lamp-cooling compartment.
Figure 2.21. Open Lamp Door and Cooling Compartment
Install one of the following lamps in the projection head, depending on your model
and site:
Single-or-3-Phase Ballast
* For this projector, the 2.0 kW is available in CDXL (maximum performance) only
** Available as CDXL (maximum performance) or original CXL (less expensive).
WARNING
Protective gear required.
Qualified service technician required.
2.0 kW *
3.0 kW **
Refer to full specifications in Section 8.
3-Phase Ballast Required
4.5 kW **
6.0 kW **
CP2000-X User Manual
020-100031-01 Rev. 1 (03-2009)