Christie CP2000-X User Manual page 56

BASIC OPERATION
TPC Alarm Window 
3-14
STATUS:SYSTEM MENU ENTRIES
Processor Board
Diagnostics Performed
DSP
FPGA Load
FPGA Code Valid
FPGA Initialize
FPGA McBSP XRDY
FPGA Done
FPGA Register Read/Write
Serial ID Chip
CLUT SRAM
Overlay Framestore SDRAM
Resizer FIR Chip
Resizer FIFO
Other
System Supervisor Module
Self Test
Ballast Communications
* C an also be set to trigger a full-screen flashing red alarm window on the TPC. Note that if a DMD temperature
exceeds a certain factory-set threshold for at least 2 seconds, the lamp will automatically shut down. Recovery
requires that the DMD temperature fall to a safe factory-set threshold.
In addition to the status bar at the bottom of any TPC screen, a full-screen red alarm
window flashes if one of the alarm conditions shown in the left column of Table3.2 is
encountered. If it is an interlock failure, power will no longer reach the lamp (DC
output is stopped), and the lamp button on the TPC Main menu will be disabled.
See Table 3.2.
Detected/Not Detected
OK/Failed
OK/Failed
Figure 3.5. Flashing Alarm Window
CP2000-X User Manual
020-100031-01 Rev. 1 (03-2009)