Setting The Interval For Collecting Ethernet Port Statistics - H3C S7500E Series Operation Manual

Operation Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches
Enter system view
Enter
Ethernet
port view
or port
group
view
Configure broadcast
storm suppression ratio
Configure multicast
storm suppression ratio
Configure unknown
unicast storm
suppression ratio
Note:
If you set storm suppression ratios in Ethernet port view or port group view repeatedly
for an Ethernet port that belongs to a port group, only the latest settings take effect.

1.1.7 Setting the Interval for Collecting Ethernet Port Statistics

Follow these steps to configure the interval for collecting port statistics:
To do...
system-view
Enter
interface interface-type
Ethernet
interface-number
port view
Enter port port-group { manual
group port-group-name |
view aggregation agg-id }
broadcast-suppression
{ ratio | pps max-pps }
multicast-suppression
{ ratio | pps max-pps }
unicast-suppression { ratio |
pps max-pps }
Chapter 1 Port Correlation Configuration
Use the command...
1-6
Remarks
—
Either is required.
If configured in Ethernet
port view, this feature
takes effect on the
current port only; if
configured in port group
view, this feature takes
effect on all the ports in
the port group.
Optional
By default, all broadcast
traffic is allowed to pass
through a port, that is,
broadcast traffic is not
suppressed.
Optional
By default, all multicast
traffic is allowed to pass
through a port, that is,
multicast traffic is not
suppressed.
Optional
By default, all unknown
unicast traffic is allowed
to pass through a port,
that is, unknown unicast
traffic is not suppressed.