H3C S7500E Series Operation Manual page 26

Operation Manual – Login
H3C S7500E Series Ethernet Switches
Figure 2-3 Specify the port used to establish the connection
Figure 2-4 Set port parameters terminal window
Turn on the switch. The user will be prompted to press the Enter key if the switch
successfully completes POST (power-on self test). The prompt (such as <H3C>)
appears after the user presses the Enter key.
You can then configure the switch or check the information about the switch by
executing commands. You can also acquire help by type the ? character. Refer to
the following chapters for information about the commands.
Chapter 2 Logging in Through the Console Port
2-3