Specifying The Root Bridge Or A Secondary Root Bridge - H3C S7500E Series Operation Manual

Operation Manual – MSTP
H3C S7500E Series Ethernet Switches
II. Configuration example
# Configure the MST region name to be "info", the MSTP revision level to be 1, and
VLAN 2 through VLAN 10 to be mapped to instance 1 and VLAN 20 through VLAN 30
to instance 2.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] region-name info
[Sysname-mst-region] instance 1 vlan 2 to 10
[Sysname-mst-region] instance 2 vlan 20 to 30
[Sysname-mst-region] revision-level 1
[Sysname-mst-region] active region-configuration

1.3.2 Specifying the Root Bridge or a Secondary Root Bridge

MSTP can determine the root bridge of a spanning tree through MSTP calculation.
Alternatively, you can specify the current device as the root bridge using the commands
provided by the system.
I. Specifying the current device as the root bridge of a specific spanning tree
Follow these steps to specify the current device as the root bridge of a specific
spanning tree:
To do...
Enter system view
Specify the current
device as the root
bridge of a specific
spanning tree
II. Specifying the current device as a secondary root bridge of a specific
spanning tree
Follow these steps to specify the current device as a secondary root bridge of a specific
spanning tree:
Enter system view
Specify the current device
as a secondary root
bridge of a specific
spanning tree
Use the command...
system-view
stp [ instance instance-id ] root
primary [ bridge-diameter
bridge-number ] [ hello-time
centi-seconds ]
To do...
system-view
stp [ instance instance-id ]
root secondary
[ bridge-diameter
bridge-number ] [ hello-time
centi-seconds ]
Use the command...
1-21
Chapter 1 MSTP Configuration
Remarks
—
Required
By default, a device
does not function as
the root bridge.
Remarks
—
Required
By default, a device
does not function as a
secondary root bridge.