H3C S7500E Series Operation Manual page 120

Operation Manual – VLAN
H3C S7500E Series Ethernet Switches
# Enable GVRP globally.
<DeviceA> system-view
[DeviceA] gvrp
# Configure port Ethernet 2/0/1 as a trunk port, allowing all VLANs to pass.
[DeviceA] interface ethernet 2/0/1
[DeviceA-Ethernet2/0/1] port link-type trunk
[DeviceA-Ethernet2/0/1] port trunk permit vlan all
# Enable GVRP on the port.
[DeviceA-Ethernet2/0/1] gvrp
[DeviceA-Ethernet2/0/1] quit
# Create VLAN 2 (a static VLAN).
[DeviceA] vlan 2
2) Configure Device B
# Enable GVRP globally.
<DeviceB> system-view
[DeviceB] gvrp
# Configure port Ethernet 2/0/1 as a trunk port, allowing all VLANs to pass.
[DeviceB] interface ethernet 2/0/1
[DeviceB-Ethernet2/0/1] port link-type trunk
[DeviceB-Ethernet2/0/1] port trunk permit vlan all
# Enable GVRP on the port.
[DeviceB-Ethernet2/0/1] gvrp
[DeviceB-Ethernet2/0/1] quit
# Create VLAN 3 (a static VLAN).
[DeviceB] vlan 3
3) Verify the configuration
# Display dynamic VLAN information on Device A.
[DeviceA] display vlan dynamic
Now, the following dynamic VLAN exist(s):
3
# Display dynamic VLAN information on Device B.
[DeviceB] display vlan dynamic
Now, the following dynamic VLAN exist(s):
2
4-8
Chapter 4 GVRP Configuration