Configuring A Trunk-Port-Based Vlan - H3C S7500E Series Operation Manual

Operation Manual – VLAN
H3C S7500E Series Ethernet Switches
Add access ports to the
current VLAN
Follow these steps to configure an Access-port-based VLAN in Ethernet port view/port
group view:
Enter system view
Enter
Ethernet
port view
or port
group
view
Configure the port link
type as Access
Add the current Access
port to a specified VLAN
Note:
Before adding an Access port to a VLAN, make sure the VLAN already exists.

1.4.3 Configuring a Trunk-Port-Based VLAN

A trunk port may belong to multiple VLANs, and you can only perform this configuration
in Ethernet port view or port group view.
Follow these steps to configure a Trunk-port-based VLAN:
To do...
port interface-list
To do...
system-view
Enter
interface interface-type
Ethernet port
interface-number
view
port-group { manual
Enter port
port-group-name |
group view
aggregation agg-id }
port link-type access
port access vlan vlan-id
Use the command...
Use the command...
1-8
Chapter 1 VLAN Configuration
Remarks
Required
By default, all the ports
belong to VLAN 1
Remarks
—
Use either command
Under Ethernet port view,
the subsequent
configurations only apply
to the current port; under
port group view, the
subsequent
configurations apply to all
the ports in the port group
Optional
The link type of a port is
Access by default
Optional
By default, all the Access
ports belong to VLAN 1