H3C S7500E Series Operation Manual page 185

Operation Manual – Link Aggregation
H3C S7500E Series Ethernet Switches
# Add ports Ethernet 2/0/1 through Ethernet 2/0/3 to the group.
[SwitchA] interface Ethernet 2/0/1
[SwitchA-Ethernet2/0/1] port link-aggregation group 1
[SwitchA-Ethernet2/0/1] interface Ethernet 2/0/2
[SwitchA-Ethernet2/0/2] port link-aggregation group 1
[SwitchA-Ethernet2/0/2] interface Ethernet 2/0/3
[SwitchA-Ethernet2/0/3] port link-aggregation group 1
2) In static aggregation approach
# Create static aggregation group 1.
<SwitchA> system-view
[SwitchA] link-aggregation group 1 mode static
# Add ports Ethernet 2/0/1 through Ethernet 2/0/3 to the group.
[SwitchA] interface Ethernet 2/0/1
[SwitchA-Ethernet2/0/1] port link-aggregation group 1
[SwitchA-Ethernet2/0/1] interface Ethernet 2/0/2
[SwitchA-Ethernet2/0/2] port link-aggregation group 1
[SwitchA-Ethernet2/0/2] interface Ethernet 2/0/3
[SwitchA-Ethernet2/0/3] port link-aggregation group 1
3) Configure a service loop group
# Create a manual aggregation group.
<SwitchA> system-view
[SwitchA] link-aggregation group 1 mode manual
# Specify this group to be a tunnel service loop group.
[SwitchA] link-aggregation group 1 service-type tunnel
# Assign port Ethernet 2/0/1 to the service loop group.
[SwitchA] interface Ethernet 2/0/1
[SwitchA-Ethernet2/0/1] undo stp
[SwitchA-Ethernet2/0/1] port link-aggregation group 1
Chapter 2 Link Aggregation Configuration
2-6