Setting The Interval For Collecting Ethernet Port Statistics; Enabling Forwarding Of Jumbo Frames - H3C S5120-SI Series Operation Manual

As for an Ethernet port belongs to a port group, if you set a storm suppression ratio for the interface in
both Ethernet port view and port group view, the one configured the last takes effect.

Setting the Interval for Collecting Ethernet port Statistics

Follow these steps to configure the interval for collecting interface statistics:
To do...
Enter system view
Enter Ethernet port view
Configure the interval for
collecting interface statistics

Enabling Forwarding of Jumbo Frames

Due to tremendous amount of traffic occurring on an Ethernet port, it is likely that some frames greater
than the standard Ethernet frame size are received. Such frames (called jumbo frames) will be dropped.
With forwarding of jumbo frames enabled, the system does not drop all the jumbo frames. Instead, it
continues to process jumbo frames with a size greater than the standard Ethernet frame size and yet
within the specified parameter range.
In global configuration mode (system view), you can set the length of jumbo frames that can pass
through the Ethernet port.
Follow these steps to enable the forwarding of jumbo frames:
To do...
Enter system view
Enable the forwarding of jumbo
frames
Use the command...
system-view
interface interface-type
interface-number
flow-interval interval
Use the command...
system-view
jumboframe enable
1-6
Remarks
—
—
Optional
The default interval for
collecting interface statistics is
300 seconds.
Remarks
—
Optional.
By default, the device
allows jumbo frames with
the length of 10240 bytes
to pass through all Layer 2
Ethernet ports.