Setting The Interval For Collecting Ethernet Interface Statistics - H3C S9500 Series Operation Manual

Operation Manual – Ethernet Interface
H3C S9500 Series Routing Switches
Note:
You cannot enable broadcast suppression and multicast suppression on a board at
the same time. If you have enabled broadcast suppression on some ports of a board,
you cannot enable multicast suppression on the other ports, and vice versa.
Before enabling multicast suppression on a port, you must disable broadcast
suppression on all the other ports on the same board. Similarly, before enabling
broadcast suppression on a port, you must disable multicast suppression on all the
other ports on the same board.
The multicast suppression function suppresses broadcast traffic in addition to
multicast traffic but the broadcast suppression does not suppress multicast traffic.

1.1.9 Setting the Interval for Collecting Ethernet Interface Statistics

Complete the following configuration tasks to configure the time interval for collecting
interface statistics. Use the display interface command to display the interface
statistics within the current interval.
Follow these steps to configure the interval for collecting Ethernet interface statistics:
Enter system view
Enter Ethernet interface
view
Configure the time interval
for collecting interface
statistics
1.1.10 Setting the Maximum Jumbo Frame Size for Ethernet Interfaces
Usually, an Ethernet interface discards received jumbo frames (frames larger than the
standard Ethernet frame size) directly without processing them. To handle jumbo
frames under a certain size, which may be received during large-throughput data
switching like file transfer, you can set a jumbo Ethernet frame size limit on the switch.
Follow these steps to set the maximum jumbo frame size for the Ethernet interfaces on
a board:
To do...
system-view
interface interface-type
interface-number
flow-interval interval
Chapter 1 Ethernet Interface Configuration
Use the command...
1-8
Remarks
—
—
Required
Defaults to 300 seconds.