Setting The Statistics Polling Interval; Forcibly Bringing Up A Fiber Port - H3C S7500X Series Interface Configuration Manual

LSQM1GT48FD0.

LSQM1TGT24FD0.

•
SA interface module: LSQM2GT48SA0.
•
SC interface modules:
LSQM2GT24PTSSC0.

LSQM2GT24TSSC0.

LSQM4GV48SC0.

LSQM2GT48SC0.

•
For this feature to take effect on an interface, configure the interface to automatically negotiate
a speed or duplex mode with the remote end.
Configuration procedure
To enable EEE on an Ethernet interface:
Step
1. Enter system view.
2. Enter Ethernet interface
view.
3. Enable EEE on the
Ethernet interface.

Setting the statistics polling interval

Step
1. Enter system view.
2. Enter Ethernet interface
view.
3. Set the statistics polling
interval for the Ethernet
interface.
To display the interface statistics collected in the most recent statistics polling interval, use the
display interface command.

Forcibly bringing up a fiber port

As shown in
physical state of the fiber port is up only when both transmit and receive fibers are physically
connected. If one of the fibers is disconnected, the fiber port does not work.
To enable a fiber port to forward traffic over a single link, you can use the port up-mode command.
This command forcibly brings up a fiber port, even when no fiber links or transceiver modules are
present for the fiber port. When one fiber link is present and up, the fiber port can forward packets
over the link unidirectionally.
Command
system-view
interface interface-type
interface-number
eee enable
Command
system-view
interface interface-type
interface-number
flow-interval interval
Figure 2, a fiber port uses separate fibers for transmitting and receiving packets. The
Remarks
N/A
N/A
By default, the statistics polling
interval is 300 seconds.
14
Remarks
N/A
N/A
By default, EEE is disabled on
an Ethernet interface.