Installing Rsm100 Software - Toshiba RSM 100 Instruction Manual

3. Installing RSM100 Software

The install method of RSM100 software is depending on its software version. The RSM100
software version is labeled on the CD-ROM.
Note:
When installing the RSM100 software on a PC, the operating system Microsoft Windows NT®,
Windows® 2000, Windows® XP, or Windows® Vista must already have been installed. These
operating systems must be also English version.
Note:
Note:
Installation
Take the following steps to install the RSM100 software using the setup program. The setup
program is delivered on a CD-ROM.
If you have previously installed an old version of RSM100 and are installing the new version, you
can overwrite the new version without uninstalling the old version.
Note:
Note:
To install RSM100, do the followings:
• Close all the applications.
• Insert the CD-ROM into a CDROM drive. Then the RSM100 setup program starts
automatically and the window below pops up. If the window does not appear automatically,
execute "\RSM100\setup.exe" in the CD-ROM.
Install the RSM100 by right of administrator.
Must uninstall the RSM100 if the CD Version is not 11.00 or later.
To install the RSM100 software requires Windows® Installer 2.0 or later.
If the installer is not included in the operating system of your PC, it will be automatically
installed. If the automatic install is blocked, install it manually from the web site of
Microsoft Corporation.
It is recommended to start to reinstall the new version after saving them in another folder
when there are some files made or saved by user in the folder of RSM100. In case of the
same name file, it is overwritten. In case of installation by overwriting, the folder or file
installed by the old version may remain.
If the folder configuration is largely changed, the new version of RSM100 may not be
installed. Uninstall the old version in this case.
⎯ 13 ⎯
6 F 2 S 0 7 1 5