Active And Passive Stereo 3D Configurations - Christie Mirage M Series User Manual
High resolution video/graphics three chip 1080p hd, sxga+, and wuxga projectors.
Hide thumbs
Also See for Mirage M Series:
- User manual (162 pages) ,
- Setup manual (72 pages) ,
- Instruction sheet (3 pages)
Table of Contents
Advertisement
Active and passive Stereo 3D configurations
Typical hardware configurations for active and passive Stereo 3D systems are shown below.
"
3D Active Filter
•
Appropriate Stereo 3D Source—Use stereo 3D application software with your 3D video
source (usually a workstation or PC). The source must also provide a separate stereo 3D
synchronization signal that precisely controls when left/right fields are visible through the
viewer's glasses. This separate signal is usually provided using a VESA 3-pin stereo port.
•
IR Emitter/3D Passive Filter System—In response to an incoming sync signal, the emitter
emits L/R infrared signals to a receiver in active 3D shutter glasses, causing the L/R shutters to
alternately open and close for active stereo 3D applications. Likewise, a 3D passive filter system
placed in front of the lens responds to an incoming sync signal and alternately polarizes the L/R
frames viewed with passive glasses for active stereo 3D applications. Connecting one of the 3D
Mirage M Series User Manual
020-101942-02 Rev. 1 (10-2018)
http://www.pureglare.com.au
"
Cell
Operating the projector
Server/PC with
Stereo 3D-capable
Graphics Card
77
Advertisement
Table of Contents
