Configuring Your Ultra1500 Drive - Allen-Bradley Ultra1500 2092-DA1 User Manual

Configuring your Ultra1500
Drive
4. Look for the Ultra1500 icon (1.5k) under the On-Line Drives tree.
The Ultra1500 icon indicates that your drive is detected.
5. 5.Click on the [+] next to the Ultra1500 icon to expand the branch menu
(as indicated in the window above).
If your Ultra3000 drive:
Is detected and listed under
the On-Line Drives tree
Is not detected
This procedure assumes you have power applied to your drive and the drive is
detected by the Ultraware software.
Ultraware software provides a simple yet powerful way to configure your
Ultra1500 for a variety of applications. The Setup Wizard walks you through
configuration screens that prompt you to make selections when appropriate.
Typically, few adjustments are needed after using the Setup Wizard.
Note: In some applications, additional configuration may be necessary using
the Ultraware properties setup screens.
To configure your Ultra1500 drive:
1. Start Ultraware software and allow it to detect the Ultra1500 drive.
Commissioning Your Ultra1500
Then:
The software and hardware are communicating and the system is
ready.
Go to the section Configuring your Ultra1500 Drive.
Check your serial cable, and then repeat steps 1 through 5.
Publication 2092-UM001D-EN-P — July 2005
4-3