Detecting Your Ultra1500 Drive - Allen-Bradley Ultra1500 2092-DA1 User Manual

4-2 Commissioning Your Ultra1500
Detecting Your Ultra1500
Drive
Publication 2092-UM001D-EN-P — July 2005
Figure 4.1
Ultra1500 Operator Interface at Startup
Startup Normal
MAIN
POWER
3. Verify the status of the drive startup, as outlined below and shown in
Figure 4.1.
If the six characters on the
7-segment display indicate:
rdY in the three least
significant characters
E. in the most significant
character followed by a text
string or error code number.
This procedure assumes you have successfully applied power to your drive.
Follow the steps below to ensure your Ultra1500 drive is communicating with
your Ultraware software.
To detect your Ultra1500 drive:
1. Start your Ultraware software.
Note: Refer to the Ultraware Installation Instructions (publication
2098-IN002B-EN-P) and/or the Ultraware on-line Help for more
information on installing and starting the software.
2. Ultraware will scan for on-line drives.
3. Click on the Stop Scanning button when your drive is detected, or wait
for the scan to complete.
Startup Error (004) Detected
CONTROL
MAIN
POWER POWER
Then:
The drive is ready.
Go to Detecting Your Ultra1500 Drive
Refer to Error Displays on page 6-5 to troubleshoot the fault
condition.
Note: If a TL-Series motor is not connected, a fault condition is
normal. Go to Detecting Your Ultra1500 Drive.
CONTROL
POWER