Commissioning Your Ultra1500; Applying Power To Your Ultra1500 Drive - Allen-Bradley Ultra1500 2092-DA1 User Manual

Applying Power to Your
Ultra1500 Drive
1

Commissioning Your Ultra1500

This chapter describes how to configure you Ultra1500 drive using Ultraware
software. The chapter includes these sections:

• Applying Power to Your Ultra1500 Drive

• Detecting Your Ultra1500 Drive
• Configuring your Ultra1500 Drive
• Testing Your Motor
This procedure assumes that you have:
•
wired your Ultra1500 system,
•
verified the wiring, and
•
are ready to begin using the Ultraware software.
To apply power to your Ultra1500 drive:
1. Disconnect any load to the motor.
Ensure the motor is free of all linkages when initially
IMPORTANT
applying power to the system.
2. Apply main and control input power to the Ultra1500, and observe the
Operator Interface on the front of the drive. The drive should enter a
normal startup, as outlined below and shown in Figure 4.1.
If the Main Power,
and Control Power Then:
LEDs are:
ON Go to step 3.
OFF Check your input power connections and repeat step 2, above.
Chapter
Publication 2092-UM001D-EN-P — July 2005
4