Connecting Motor Power; Wiring Motor Power - Allen-Bradley Ultra1500 2092-DA1 User Manual

3-12 Connecting Your Ultra1500

Connecting Motor Power

Publication 2092-UM001D-EN-P — July 2005
The DC bus connections should not be used for
IMPORTANT
connecting multiple drives together. Contact your
Allen-Bradley representative for further assistance if the
application may require DC power connections.
Figure 3.9
Using the Power Connector Tool
2
1. Open terminal locking clamp with connector tool as shown.
2. Insert wire, and then release tool.
3. Gently pull on the wire to make sure it is secure.
5. Tighten the ground terminal screw. to 1.25 Nm (11 lbs-in.).
6. Gently pull on each wire to make sure it does not come out of its terminal.
Re-insert any loose wires.
7. Re-insert the Input Power connector on the terminal block. The
connector is keyed to prevent incorrect installation.
This procedure assumes you have wired your input power and are ready to
wire the motor power connections.
Torque the ground screws securing the wires to 1.25 Nm
IMPORTANT
(11 lbs-in.).
To ensure system performance, run wires and cables in the
IMPORTANT
wireways as established in Chapter 1.
Refer to Figure 3.8 for the power wiring diagram for your Ultra1500.

Wiring Motor Power

When using TL-Series motors refer to Figure 3.10 for your motor power cable
configuration.