Position Regulator - Allen-Bradley Ultra1500 2092-DA1 User Manual

5-40 Ultra1500 Application Examples
Sampled
Command
Publication 2092-UM001D-EN-P — July 2005

Position Regulator

Figure 5.20 shows the block diagram of the position regulator in the Ultra1500
Figure 5.20
Position Regulator Block Diagram
-1
z
1
-
+
K
gear
Master
1
Position
1
K
gear
Block/Switch Definitions:
1 Mode Configuration : Follower : Gear Ratio
2 Tuning Window : Main Position Regulator Gains : K
3 Tuning Window : Main Position Regulator Gains : K
4 Tuning Window : Main Position Regulator Gains : K
5 Tuning Window : Main Position Regulator Gains : High Error Output Threshold
6 Tuning Window : Main Position Regulator Gains : High Error Output Offset
7 Velocity command limt to motor rated speed
Signal Definitions:
1 Delta position command (velocity command): master counts
2 Velocity command: follower counts
3 Delta position : follower counts. Fractional counts are managed here for a lossless conversion.
4 Position command : follower counts
5 Position Error : follower counts
Block/Switch definitions shown in Figure 5.20 refer to the Ultraware parameter names where applicable.
The Ultra1500 uses a fixed frequency (5 kHz) to sample data and perform
computations (i.e., the sample or update rate is 200 µs). A z
figure indicates a delay of one update period, or 200 µs. This implies that any
signal multiplied by a z
the calculation for the current update.
3
2
2
K
ff
3
4 5
+
+
+
-
-1
z
+Offset
0.0
-Offset
6
-1
block will use the signal from the previous update in
4 7
+
+
'
K
p
+
Sampled
Follower
5
(Motor)
Position
Feedback
ff
Low Pass Filter Bandwidth
ff
p
-1
block in the
Velocity
Command
To Velocity
Regulator